Why are half of my LED lights not working?

Bad Pin Connection – If your LED strip light fails to turn on at all, then check your pin connections. Most likely, the pin is not inserted correctly. In rare cases, the pin is faulty. … If your RGB strip lights won’t change colors try flipping your strip light around and reconnecting it.

Why are half of my LED lights dim?

The brighter half is the normal level of illumination. I can confirm each and every bulb is illuminated at some level. The way some strings are wired, theres three wires where one wire runs to the 2nd half of the lights to provide power. I would check where that wire goes into the male plug, it may be loose.

How do you reset LED lights?

These are the typical steps to do that:

  1. Plug your LED strips in and turn it on for a few seconds.
  2. Turn it off then take out the power adaptor without turning off the remote control.
  3. Hold the power button for five seconds then turn off the power.
  4. Wait for 3 seconds then turn it on for five seconds.

What do I do if my LED lights won’t turn on?

If the LEDs will not light up at all, then this could be down to a faulty power supply. Solution: If you have several power supplies, then try a different power supply onto the same strip to see if this now works. If it does, then you have a faulty power supply and will need a new one.

IT IS INTERESTING:  Frequent question: Can LED grow lights give you a tan?

Why wont my LED lights turn red?

Most likely it is a poor connection on the Red wire, A standard DVM meter will test LEDS like these, just set to Ohms and place the leads across a red LED and see if it lights up. If that doesn’t do it, reverse lead polarity.

Why are my LED lights only blue?

It is probably due to low voltage. The blue LED requires a higher voltage to light than the others.

Can you reconnect LED lights?

A: If the LED light strip you purchased can be cut, the remaining part that you have cut off cannot be used anymore. If you want to reconnect them after cutting, you must use an additional 4 pin connector to reconnect. … If you need to reconnect LED light strips after cutting it, you need an additional 4pin connector.

Why won’t my LED lights change color?

Bad Pin Connection – If your LED strip light fails to turn on at all, then check your pin connections. … If your RGB strip lights won’t change colors try flipping your strip light around and reconnecting it. Incorrect Power Source – Make sure to double check which power source your lights require.

Why are my LED lights 2 different colors?

If two primary color within the group of three LED elements are missing, this simply means that two surface-mounted components (resistors) have been damaged. Observe the PCB strip around the location of the missing primary color (red, green, or blue) and see if you see any damage.

IT IS INTERESTING:  How can I brighten my LED lights?

Why are my LED lights showing the wrong color?

The biggest reason behind wrong colors showing up on your LED lights is because the wires aren’t properly plugged in as they should. To fix this, first, you will need to make sure the black wire on the RGB strip connector is on the exact same side as the +12V is, which is normally found on one side of each strip.

Spotlight