Quick Answer: Why isn’t my remote working for my LED lights?

If your remote control suddenly stops working or your lights start blinking, you may need to reset the controller and pair it back to the receiver unit. … Remove battery from controller and then reinstall. Plug power supply and LED strip back into the receiver unit (Figure 2) Reconnect power supply to power.

How do I reset my LED remote?

Step 1: press the red key. Step 2: press the power off. Step 3: press fade 7 (or bottom right corner button). Step 4: turn power on, repeat steps 2,3+4 until led is red.

Can you use any remote for LED lights?

Order a New Remote

Although you can use a few functions of some LED light strips without needing a remote, you will need a new remote to be able to fully control the lights.

How do you reset LED lights without remote?

How To Reset LED Strips

  1. Plug your LED strips in and turn it on for a few seconds.
  2. Turn it off then take out the power adaptor without turning off the remote control.
  3. Press and hold the power button for a few seconds then connect the power supply again.
IT IS INTERESTING:  How does an LED tube light work?

What do you do if your LED lights don’t work?

Check for any visible loose connections, make sure all of your connectors and wires are in place and have not fallen out. Try tightening screws on DC adapters, and re-inserting LED strips into solderless connectors, which are common contact failure points.

Why are my LED lights 2 different colors?

As established above, when LED strip lights don’t get enough cooling, they get overheated, and the diodes can change color.

How do you connect your LED lights to your phone?

How to Use Smart LED Strip Lights with EZ Mode

  1. Step 1: Download LampUX App. Android and iOS users can go to the App store and download LampUX App on your phone, then register an account.
  2. Step 2: Set Up the Smart LED Light Strip. Turn on the LED strip lights and wait for 10 seconds. …
  3. Step 3: Connect the App.

17 июл. 2020 г.

What does DIY mean on LED light remote?

Using the “DIY” buttons on the controller you can create custom colors. When you press one of the six DIY buttons, the color will change to white, from there, use the color coded arrows on the controller to change the color to whatever you like!

How do I get my LED remote to work?

How to fix your LED Strip Controller

  1. First make sure that the indicator light on the top of the remote is lighting up when you press a button. …
  2. Disconnect your power source.
  3. Unplug the dimming wire from both the power supply and LED strip light (see figure 1).
  4. Remove battery from controller and then reinstall.
IT IS INTERESTING:  Why is one LED strip brighter than the other?

20 июн. 2019 г.

Why isn’t my DIY LED lights working?

Could be, your lights are a series circuit, one of the LED isn’t seated correctly or maybe defective, causing the strip to fail. The LED are actually a DC device and are not like a filament light bulb. Could be your voltage is wrong for the LED to operate correctly.

How do you fix your LED lights of the colors are wrong?

Step 1, Make sure all part of the LED strips kit are connects right and powered. Step 3, Press the “FADE7” button ,it will flash one second. Step 4, Turn on the LED strips again, press Red, Green, blue button one by one, it will change to its original color.

Why are my LED lights showing the wrong color?

The biggest reason behind wrong colors showing up on your LED lights is because the wires aren’t properly plugged in as they should. To fix this, first, you will need to make sure the black wire on the RGB strip connector is on the exact same side as the +12V is, which is normally found on one side of each strip.

Spotlight