How do you connect my LED lights to my phone?

What app do you use for LED lights?

What is Lumenplay®? Lumenplay® is an extendable string of app-enabled RGB LED lights that enables you to create scenes of color and motion, all from your smart device. Use the free Lumenplay® app to setup a personalized light show by choosing color combinations, effects, speed, direction and brightness.

Why are my LED lights not connecting?

Bad Pin Connection – If your LED strip light fails to turn on at all, then check your pin connections. Most likely, the pin is not inserted correctly. In rare cases, the pin is faulty. … If your RGB strip lights won’t change colors try flipping your strip light around and reconnecting it.

Can you use your phone for LED lights?

“For years, home automation has controlled light fixtures with plug-in lamp modules, wire-in switches, and keypads. But, until now, no one has controlled the bulb itself. … Compatible on both iOS and Android systems, the new bulb can be controlled by mobile devices including phones or tablets.

IT IS INTERESTING:  Do LED brake lights need a load resistor?

How do I control my led phone with Daybetter?

App Controlled: Use the “Magic Home”APP to turn on or change your lights strip’s color. The WiFi remote controller only work on 2.4G network, and they supports both IOS 6.0 or above and Android 2.3 or above.

How do you connect Monster LED strip lights to your phone?

1: Press and hold the pairing button on the device and ensure that the LED indicator is now blinking RAPIDLY. 2: Open the Monster Smart app. From the add device list, click on “Lighting (WiFi)”. 3: Follow the on-screen instructions to confirm that the LED indicator is rapidly blinking.

How do you connect LED lights to smart life?

kindly connect it as below steps: Open “smart life” app after your register it > click “+” on the top right > click “All devices”> click” lighting devices”> then press and hold the wifi led controller for 5-6 seconds > then click the “confirm light blinks rapidly” in the app.>

Why are my LED lights 2 different colors?

If two primary color within the group of three LED elements are missing, this simply means that two surface-mounted components (resistors) have been damaged. Observe the PCB strip around the location of the missing primary color (red, green, or blue) and see if you see any damage.

How do you reset LED lights yourself?

Here’s how to do it:

  1. Plug your LED strips in and turn it on for a few seconds.
  2. Turn it off then take out the power adaptor without turning off the remote control.
  3. Press and hold the power button for a few seconds then connect the power supply again.
IT IS INTERESTING:  You asked: How do you make LED lights bright yellow?

Why did my LED lights stop working out of nowhere?

If the LEDs will not light up at all, then this could be down to a faulty power supply. Solution: If you have several power supplies, then try a different power supply onto the same strip to see if this now works. If it does, then you have a faulty power supply and will need a new one.

Can I connect a different remote to my LED lights?

Yes,One remote can control multiple receriver, you need to match code with receiver firstly,following the steps: plug in the LED strips light with the receiver and power supply, using remote, holding the “ON” 5 seconds, then LED strips light would flash,it means the remote has paired with the receiver successfully, rep …

How do I sync my monster LED strips?

To pair LED strips or LED light bulbs to another remote, simply unplug and replug back in the LED strip or lamp to power and WITHIN FIVE SECONDS of plugging back into power, press and hold the “Speed+” until the lights blink three times.

What does DIY mean on LED light remote?

Using the “DIY” buttons on the controller you can create custom colors. When you press one of the six DIY buttons, the color will change to white, from there, use the color coded arrows on the controller to change the color to whatever you like!

Spotlight