Room | Foot Candles Needed |
---|---|

Dining Room | 30-40 |

Bedroom | 10-20 |

Hallway | 5-10 |

Bathroom | 70-80 |

## How many watts should a bedroom light be?

For a room with decent natural light, that should be around 60 watts. For a room with few/no windows, balance the 60 watt desk light with ambient overhead lights or bump that number up to 75 watts.

## How many can lights for a 12×12 room?

The typical rule-of-thumb is 24″ from each wall, and then 3-5 feet between cans. So in a 12′ room you’d probably want two rows of lights. Considering it is a bedroom and you don’t need it as bright as a kitchen, you can probably get away with 2 rows of 4 lights for a total of 8.

## How do you calculate the amount of light needed in a room?

Multiply width of room x length of room x 1.5 = amount of total minimum wattage needed (assuming an eight foot ceiling). Divide by 60 to get the number of 60-watt equivalent bulbs required. Then, add up the wattage in each bulb in each fixture to figure out how many light fixtures are needed.

## How many watts should a bedroom ceiling light be?

So if you have an 18′ long room x 12′ wide room multiply times 1.5 = 324 watts, that’s how much wattage is needed to adequately light the room. You can divide that lighting into more than one source. 2 Lamps @ 150 watts each and 1 lamp @ 60 watt would be more than adequate light for the room.

## Which is better 40W or 60W?

So if a package for a lightbulb says the bulb uses 60 watts, or 60W, it means that that bulb will use 60 watts of electrical power. … A standard 40W bulb is equal to 400+ lumens, which represents the brightness of a bulb. Typically, the higher the wattage, the higher the lumens, and the more light output.

## Should I use 4 or 6 recessed lights?

Choose one that will accommodate the height of your ceiling or the size of your wall. 4-inch and 5-inch fixtures are great in kitchens for providing overhead countertop lighting. 6-inch fixtures are most common for general lighting purposes. 7- to 9-inch fixtures will create a wider wash of light.

## How many can lights in a 20×20 room?

Beside above, how many can lights in a 20×20 room? If you have a center light fixture, you should be able to use the 4 4″ line voltage cans or low voltage for supplemental lighting. for a 20 foot room i would go with at least 8 three inch cans.

## How many can lights for 15×15 room?

Measure your room to see how many fixtures you will need. A common rule of thumb is that you use one recessed light for every 4 to 6 square feet of ceiling space. Doing so provides even, overall illumination.

## Is 3000 lumens too bright?

In other words, 3,000 lumens is meant to give a room a brighter light. This is not ideal if you have a small room and it’s a bedroom. You don’t want to blind your eyes when you’re about to go to bed. On the other hand, 2,000 lumens is ideal if you wish to light up a 200 square-foot living room.

## How do I calculate LED lights for a room?

To determine the needed lumens, you will need to multiply your room square footage by your room foot-candle requirement. For example, a 100 square foot living room, which needs 10-20 foot-candles, will need 1,000-2,000 lumens. A 100 square foot dining room, which needs 30-40 foot-candles, will need 3,000-4,000 lumens.

## How many LED lights can be on a 15 amp circuit?

Breaker Limitations

Each CFL or LED bulb typically gives the same amount of light as a 60-watt incandescent bulb while drawing 10 watts or less, which is equivalent to a current draw of 1/12 amp. Thus a 15-amp circuit can safely control 180 or more fixtures that use CFL or LED bulbs.

## What is the maximum wattage for a ceiling light?

If a fixture is rated for a maximum of 60 watts, then it’s dangerous to exceed that. A 100-watt bulb will draw more power through the wires than they safely can handle. (It is okay, however, to put a bulb with lower wattage in that fixture—drawing less than the wire’s maximum load isn’t a problem.)

## Is 100 watts a lot?

A kilowatt-hour is 1,000 watts used for one hour. As an example, a 100-watt light bulb operating for ten hours would use one kilowatt-hour. Below are some examples of electrical appliances found in most homes. These examples are using a 10 cents per kWh rate.

## How do I choose a light for my bedroom?

As your build your layers of light, remember that bedroom lighting should create a peaceful, relaxing atmosphere using soft, flattering ambient light while providing bright spots in the places where they are needed. When developing your bedroom lighting design, first consider the size and ceiling height of your room.